Installation Procedures - HP 9000 Installation Manual

Installation Procedures

A. Install Fast/Wide Fast/Wide SCSI disks (or Hot-Swap disks) can be installed while system
SCSI Disks
power is ON or OFF.
CAUTION You must follow proper hot-swap procedures before adding or replacing a
Fast/Wide SCSI disk. Refer to the Hot-Swap Procedure Guide for hot-
swap procedures and information before performing the following
installation procedure.
NOTE The hot-swap capability (up to five disks) is standard on Model D3xx
servers, and is available as a two-disk option on Model D2xx servers. To
add the optional hot-swap capability to your D2xx server, refer to the
procedure described in step K of this manual, then return to step A to
add the hot-swap disks.
1. Unlock the peripheral door using the key that was shipped with your
2. Pull out the latch of the disk so that it is in the open position.
3. Insert the disk into the peripheral slot.
Chapter 1
server. Open the peripheral door.
D Class Internal Peripherals Installation
Installation Procedures
1- 3