HP 9000 Installation Manual page 29

C. Observe Console During the power-on cycle, the system will perform selftests. These
Display
selftests may generate messages that will appear on the console screen if
a problem is detected.
D. Verify Peripheral At the operating system interface, you can run the online diagnostics to
Installation
verify the peripherals installation. The diagnostics are available in the
Support Tools Manager, in three different user interfaces:
• Graphical user interface (xstm)
• Menu interface (mstm)
• Command line interface (cstm)
Graphical User • To use the graphical user interface, you must have a graphics console
Interface (XSTM)
• To access the graphical user interface, type xstm at the operating
• Use the mouse to point and click on menus or components on the
Menu Interface (MSTM) • To access the menu interface, type mstm.
• You can verify the installed peripherals by pressing the Verify
• You can press the Help function key at any time to get more
• To access the command line interface, type cstm.
Command Line User
Interface (CSTM)
• To get more information, type help.
After running the desired verification diagnostics, the peripherals
installation is completed.
If the verification procedure indicates that a problem exists, contact an
HP Service Representative.
Chapter 1
running HP VUE.
system prompt in a terminal window.
map.
function key.
information.
D Class Internal Peripherals Installation
Peripherals Installation Verification Procedure
1- 23