HP 9000 Installation Manual page 14

D Class Internal Peripherals Installation
Installation Procedures
E. Remove the EMI D Class servers that have the Hot-Swap Module installed will have an
Cover
EMI cover installed over the processor/memory card. To remove the EMI
cover:
1. Loosen the two notches at the bottom of the EMI cover from the tabs
2. Pull the EMI cover down slightly until the two notches at the top of
3. Loosen and remove the SCSI ribbon cable from the Fast/Wide SCSI
4. Remove the other end of the SCSI ribbon cable from the connector on
F. Configure Your Before installing a peripheral, verify that it is configured correctly. Refer
Peripheral
to the configuration information in the manual shipped with your
peripheral device. After configuring the peripheral device, proceed to the
following step.
1-8
on the processor/memory card by pushing up and slightly flexing the
EMI cover until the notches come loose.
the cover come loose from the tabs at the top of the server cabinet.
card.
the hot- swap backplane, and set the EMI cover and ribbon cable
aside.
Chapter 1