HP 9000 Installation Manual page 42

R Class Internal Peripherals Installation
Installation Procedures
J. Install Single-
Up to two single-ended SCSI disks can be installed in slots next to the removeable
Ended SCSI Disks
media drives.
1. Remove the two screws securing the SCSI disk drive bay cover to the chassis,
2. Insert each single-ended SCSI disk drive mechanism into a bracket.
3. Secure each drive to its bracket with four (4) screws (two on each side).
4. Insert the SCSI drives and brackets into one of the two slots next to the
5. Connect the SCSI ribbon cable and the power cables to the rear connectors of
6. Connect the other end of the SCSI ribbon cable to the internal single-ended
2-12
*** GRAPHIC NOT PROVIDED***
and remove the cover.
removable media drive in the server cabinet. Replace the cover piece and secure
it to the cabinet with two (2) screws.
the disk assemblies.
SCSI connector on the system board.