HP 9000 Installation Manual page 23

D class and r class internal peripherals enterprise servers

Hide thumbs Also See for 9000:

L. Replace the EMI

If you removed the EMI cover in a previous step, or are adding the hot-

Cover

swap disk option, install the EMI cover now. To install the EMI cover:

NOTE

If you are adding the hot-swap disk option, you must route the Fast/Wide

SCSI ribbon cable for the hot-swap disk bay through two ferrites

attached to the EMI cover, as shown in the figure below.

1. Place the EMI cover and SCSI ribbon cable close enough to the upper

2. Insert the two upper notches of the EMI cover onto the tabs at the top

3. Flex the EMI cover slightly to insert the two notches at the bottom of

4. Connect the lower end of the SCSI ribbon cable on the EMI cover to

Chapter 1

cabinet to connect the upper end of the ribbon cable to the connector

on the Fast/Wide SCSI card.

of the server cabinet.

the EMI cover onto the tabs of the processor/memory card.

the backplane connector on the Hot-Swap Module.

D Class Internal Peripherals Installation

Installation Procedures

1- 17

Table of Contents