HP 9000 Installation Manual page 16

D Class Internal Peripherals Installation
Installation Procedures
H. Install the IDE 1. Install the IDE floppy drive in the top slot of the peripheral bay, and
Floppy Drive
2. Connect the data cable (ribbon cable) and the power supply cable to
3. Connect the other end of the data cable (ribbon cable) to the internal
NOTE The power supply cable for the floppy drive branches off from the main
power supply cable for the peripheral located just underneath the floppy
drive (inside the removable media bracket). Route the floppy power
supply cable from inside the bracket through the hole in the top of the
bracket, as shown in item 2 in the next diagram.
1-10
secure it with two (2) Torx #15 screws.
the rear of the floppy drive assembly. The connector on the ribbon
cable for the floppy is marked "This End to Floppy."
IDE connector on the system board.
Chapter 1