Korg prologue Owner's Manual page 8

6.
MIDI IN/OUT connectors
These connectors allow the prologue to exchange MIDI messages with an exter-
nal MIDI device. Refer to "Using with other MIDI devices" (p.66) for details.
7.
SYNC IN/OUT jacks
Use a stereo mini-cable to connect the prologue to the Korg volca series and
other instruments. This is used to synchronize the steps of the prologue with the
pulses sent from the audio out jack of connected devices, DAWs and so on. Refer
to "Syncing to instruments with SYNC IN/OUT jacks" (p.64) for details.
8.
OUTPUT L/MONO, R jacks
These jacks are for stereo output. Connect these jacks to a powered monitor
speaker or mixer. The volume level is adjusted using the MASTER knob. To out-
put monaural sound, use the OUTPUT L/MONO jack.
9.
(Headphone jack)
This jack outputs the same signal as that of the OUTPUT jack. Connect your
headphone plug here.
Connecting to audio devices
• C onnect your powered monitor speaker, mixer or other components to the OUT-
PUT jack (monaural output) of the prologue. Adjust the volume level using the
MASTER knob.
• C onnect your headphones to the headphones jack. This jack outputs the same sig-
nal as that of the OUTPUT jack.
Connecting to MIDI devices or a computer
• T o exchange MIDI messages with an external MIDI device, connect the device to
the MIDI IN/OUT connectors on the prologue.
• T o exchange MIDI messages with your computer, connect your computer to the
USB B connector on the prologue.
Refer to "Using with other MIDI devices" (p.66) for details.
TIP
Connecting the SYNC IN and OUT jacks
• U se the SYNC IN and OUT jacks when you want to synchronize the output pulses
and steps from the SYNC IN/OUT jacks of the Korg volca series or the audio out
jacks of a DAW. Use a stereo mini-cable for this connection.
• T he SYNC OUT jack sends a 5 V pulse of 15 ms at the beginning of each step.
Refer to "Syncing to instruments with SYNC IN/OUT jacks" (p.64) for
TIP
details.
8