Korg prologue Owner's Manual page 59

Button 5 (GLOBAL 5)
These parameters relate to the prologue's MIDI capabilities.
MIDI Route
MIDI signals can be sent and received via the MIDI and USB connectors, or by the
USB connector alone.
USB+MIDI: MIDI messages are received via the USB B connector and the MIDI IN
connector; messages are transmitted from the USB B connector and the MIDI OUT
connector.
USB: MIDI messages will be transmitted and received only via the USB B connector.
When using the USB connector as a MIDI interface, it is advantageous to use this
setting.
MIDI Global Ch
Specifies the global MIDI channel of the prologue.
This MIDI channel is used to transmit and receive note messages, pitch bend mes-
sage, data dump messages and control change messages for the main timbre.
The same channel cannot be selected for both "MIDI Global Ch" and "MIDI
Sub CC Ch".
MIDI Sub CC Ch
This MIDI channel is used to transmit and receive control change messages for the
sub-timbre.
Set the device to which the prologue is connected and the prologue to the same
MIDI channel.
The same channel cannot be selected for both "MIDI Global Ch" and "MIDI
Sub CC Ch".
Clock Source
Many features of the prologue can be sync'd to the tempo or BPM. This parameter
allows you to specify whether the clock source is internal, or an external MIDI Clock
Source.
Auto (USB), Auto (MIDI): When there is no input, the internal clock will be used;
and when input is detected, the internal clock will be synchronized to the clocks
from the USB B and MIDI IN connectors respectively.
Internal: Only the internal clock to be used.
When a cable is plugged into the SYNC IN jack, the internal clock is syn-
chronized to the SYNC IN jack clock, regardless of the MIDI clock settings.
[USB+MIDI, USB]
[1...16]
[1..16]
[Auto (USB), Auto (MIDI), Internal]
59