Menu Structure - ETC Response Setup Manual

ETC Setup Guide
Four-Port DIN Rail Mounted Gateway

Menu Structure

continued on
next page
Four-Port DIN Rail Mounted Gateway Setup Guide
Port 1 Output
• Displays the port priority mode (either "Output", "Input Pri***" where *** indicates
sACN 3/4:511
• Displays the patch information formatted as "universe", universe/address",
Port 1 RDM Enabled
• Displays the port RDM status (either "Enabled", "Disabled", or "Standby". This can
Discovery On #12
Port 2 Input Pri***
Custom (AIP) • Displays discovery status (either "Fast", "On", or "Off") and the number of RDM
Port 2 RDM Disabled
Hold to Enable
Port 3 Input Pri 100
sACN 2:512
Port 3 RDM Disabled
Port 4 Output
sACN 1
Port 4 RDM Enabled
Discovery Off #0
Static IP Address
• Displays either "Static" or Dynamic" IP address
10.101.50.107
• Displays the current IP address of the gateway
IP Subnet Mask
• Displays the current Subnet Mask of the gateway
255.255.0.0
IP Gateway
• Displays the current IP address for the default gateway (router.)
10.101.50.101
TFTP Server
• Displays the current Trivial File Transfer Protocol (TFTP) server IP address for the • Displays the current Trivial File Transfer Protocol (TFTP) server IP address for the
10.101.50.43
the port is set with per-address priority.
"universe/ address:length", "universe:length" or custom (AIP)"
be enabled or disabled at the gateway only if the port is set to "output" mode by
holding the Menu button for 5 seconds.
devices discovered.
gateway. The TFTP server is typically an ETC console or computer running Gateway gateway. The TFTP server is typically an ETC console or computer running Gateway
Configuration Editor (GCE) software. Configuration Editor (GCE) software.
Page 4 of 5 ETC