ETC REsponse User Manual

Network interface

Download this manual

U S E R M A N U A L

DMX512 Input

DMX512 Output

AMX192 Output

AMX192 Input

Reset switch

Indicator LEDs

DMX512 termination switch

Adjustment pots

DIP switches

Number switches

AC power cable

Converter

The Response ConverterTM network interface allows you to convert 192 DMX512 signals

to AMX192 or 192 AMX192 signals to DMX512. The compact interface box features an

optically isolated DMX512 link and a 100 hertz output update rate. This manual provides

information on all Response Converter controls, connectors and indicators.

1 1

To use Response Converter, follow these steps:

1. Plug power cable into a 120 VAC outlet.

2. For DMX512 to AMX192 operation, set DIP switch 3 down and switch 4 up. If optical

isolation is desired, set DIP switch 1 up. For AMX192 to DMX512 operation, set DIP

switch 1 down, switch 3 up and switch 4 up.

3. Press Reset.

4. Insert input and output cables into appropriate connectors.

5. Set number switches to starting dimmer output number (see page 2).

6. If Response Converter is the last device in a DMX512 data link, set DMX512

terminator switch On (right). In AMX192 to DMX512 mode, leave terminator switch Off

(left).

7. See following pages for adjustment pot settings and additional information on switch

functions and settings.

Note: When data flow is interrupted, all outputs fade to zero percent after three minutes.

1 1

Page 1 5. Set number switches to starting dimmer output number (see page 2). 6. If Response Converter is the last device in a DMX512 data link, set DMX512 terminator switch On (right). In AMX192 to DMX512 mode, leave terminator switch Off (left).
Page 2 DMX512 to AMX192 operation. For AMX192 to DMX512 operation, enter a starting number between 001 and 192. The Response Converter reads numbers over the output quantity limit as a starting address of 1. You do not have to press Reset when resetting the starting address, unless you are also ending a diagnostic test.
Page 3: Reset Switch
Bottom LED continuous Receiving power DMX512 termination switch Set the termination switch On (right) if the Response Converter is the last device in a DMX512 data stream. If you are sending a DMX512 data stream to another interface or dimming device, set the termination switch Off (left). For AMX192 to DMX512 operation, set terminator switch Off (left).
Page 4: Dip Switch Settings
Optical isolation disabled (AMX192 to DMX512) Down AC power The Response Converter has an operating range of 90 to 140 volts with optimal performance at 110 volts. It has an internal type GMA-1/2 fuse. Disconnect power before replacing fuse. Specifications Dimensions 2.25"H x 6"W x 7"D...