Top Cover - Epson L1800 Service Manual

L1800

3.7.4.2 Top Cover

Refilling Ink Label
13 ± 1 mm
6 ± 1 mm
Top Cover Label
Top Cover Label
Marking
Attach the Refilling Ink Label on the position shown in the figure above.

When attaching the Top Cover Label, align it with the markings on the Top Cover as

shown in the figure above.
Disassembly And Assembly
Refilling Ink Label
Top Cover
Top Cover Marking
Disassembling the CISS section
3.7.4.3 Tube Valve Holder Front/Rear
Ink Supply Tank Tube
Tube Valve Holder Front
Ink Supply
Tank Tube
1
2 3
Tube Valve
Holder Rear CBP. 3X6 (4±1 kgf.cm)
When routing the Ink Supply Tank Tubes, align them with their red lines facing the
Tube Valve Holder Front without any twist.
Follow the procedure below when installing the Tube Valve Holder Rear.
1. Insert the ribs (x2) of the Tube Valve Holder Rear under the hooks (x2) of the Valve
Case.
2. Align the dowels (x4) of the Tube Valve Holder Rear with the positioning holes
(x2) of the Ink Supply Tank and the positioning holes (x2) of the Tube Valve
Holder Front.
3. Make sure no Ink Supply Tank Tubes are caught, then secure it with the screws (x3)
in the order shown in the above figure.
Revision A
Tube Valve Holder Rear
Valve Case
Tube Valve Holder Rear
Back side
Tube Valve
Holder Front
Valve Case
Ink Supply Tank
Positioning Hole Dowel Rib Hook
106
Confidential