Epson L1800 Service Manual page 99

L1800
6. .Press the Driven Pulley toward the center to loosen the CR Drive Belt, and
remove the CR Drive Belt from the CR Motor Pinion Gear.
CR Drive Belt
Driven Pulley
Figure 3-142. Removing the CR Motor
7. Remove the two C.B. M3 x 4 screws that secure the CR Motor, and remove the CR
Motor from the Main Frame.
Figure 3-143. Removing the CR Motor
Disassembly And Assembly
CR Motor Pinion Gear
19) C.B. M3x4
(4±0.5 kgf.cm)
2 1
 Make the Lot No. printed surface on the CR Motor face the
direction shown in the figure below.
 Tighten the screws in the order shown in
After replacing the CR Motor, always make the required adjustments
A D J U S T M E N T
R E Q U I R E D
referring to the following.
 "Chapter 4
Removing the Motors
Lot No. Printed Surface
Figure 3-144. Reinstalling the CR Motor
Figure 3-143
Adjustment (p.109)"
Revision A
94
Confidential