Setting The Parameters For A Wired Network - T+A CALA CDR User Manual

The Configuration for a Wired Ethernet LAN or Power-Line LAN
Setting the
Parameters for
a Wired
Network

58
connection

Connect the
modem using the LAN socket on the back panel.

Open the System Configuration menu by pressing the  button
on the remote control handset or the front panel of the

Use the  /  buttons to select the "Network" menu point,
then confirm by pressing the  button.

You should now see the menu reproduced below, displaying the
network parameters. In the title line the message 'LAN' should appear,
indicating that the machine is connected to a wired LAN. If you see
'WLAN' at this point instead, please check your network connection,
and ensure that the network is switched on and operational.
 You can now select the individual menu points and adjust them to
match your network conditions. The illustration below shows the
possible button inputs after each menu item.
 / : Switching ON / OFF
(0...9): Numeric input, separating dots are automatically
generated; input limited to valid addresses
(0...9, A...Z): Alpha-numeric input and special characters.
IP - separating dots must be entered as special characters.
The parameters illustrated above are only typical values.
Addresses and settings may require different values for your network.
to an operational network or Power-Line
.
Possible entries