T+A CALA CDR User Manual page 50

WLAN
 R and  L
(loudspeaker
terminals)
50

Input socket for WLAN antenna

Automatic Activation of the WLAN Module
After powering on the MP 2000 R detects if it is connected to a
wired LAN Network. If no wired LAN connection is found, the
MP 2000 R will automatically activate its WLAN module and it will
try to get access to your WLAN network

Attention!
When WLAN shall be used, the LAN socket must be left
unconnected.

One pair of loudspeakers can be connected to the
(SPEAKER  R and SPEAKER  L). The impedance of each
speaker must not be lower than 4  (DIN rating).

Attention!
The load capacity of the loudspeakers connected to the device
must be appropriate to the amplifier. The speaker impedance must
be at least 4 Ohm (DIN rating). Always connect your loudspeakers
using ready-made, purpose-designed speaker cables terminating
in approved connectors. The speaker cables and connectors must
be insulated in accordance with regulations, and the conductors
must have a minimum cross-sectional area of 1.5 mm².The output
stages are designed to cope with a minimum load of 2 , but conti-
nuous operation at very high volume produces high currents in the
power output stages which can lead to overheating. This in turn
trips the protective circuit which switches the amplifier off
automatically. Make sure that the terminals are firmly screwed
down, and that no short-circuits are possible.

If the loudspeakers are to be used in countries outside the EU the
red/black stoppers can be removed from the loudspeaker
terminals. The speakers can then be connected using banana
plugs.
The stoppers are simply a push-fit in the terminals, and can be
prised out from the rear using a suitable tool such as a knife blade.
* The aerial can also be set up
free-standing using
magnetic base supplied in the
set; this ensures maximum
possible range.
the