Summary of Contents for DREAMS FRANCIS OTTOMAN BEDGAS LIFT
Page 1
FRANCIS OTTOMAN BED GAS LIFT PLEASE READ this sheet prior to assembly to familiarise yourself with the various stages of construction. Carefully open the pack supplied and check the contents against the parts and fittings check list. Do not destroy any of the packaging until you are certain that you have all the necessary parts for the assembly.
Page 2
Fittings Checklist HARDWARE NEEDED FOR BED ASSEMBLY (PACK A) Code Description Code Description Bolts (M8x30mm) for Allen Key (for M8 bolt) fitting side rails (3&4) to & (1&2) Bolts (M8x60mm) for fitting feet (12&13) to Spring Washers (for M8 bolts) &...
Page 3
Bed Assembly - Use Pack 'A' Stage Note angles point inside & Stage 10mm Page 3 of 9...
Page 4
Bed Assembly - Use Pack 'A' Stage & & Stage & 100% Make certain the bed is squared up as shown in the diagram then tighten all bed assembly bolts 100%. Page 4 of 9...
Page 5
Base Board Assembly Stage & Stage Page 5 of 9...
Page 6
Gas Lift Assembly i) Un-tie the two mechanisms. Stage ii) Lift up mattress base board support bars. iii) Connect the piston stems SMALL GAP Hold up each arm and slide piston stem onto the threaded axle and fit nut (G) using spanner (F). Note, do not overtighten - a small gap needs to be left - see sketch.
Page 7
Mattress Base Assembly - Use Pack 'B' Stage SLIDE HEADEND MATTRESS BASE BOARD (5) UP AGAINST THE LIFTING ARM STOP PLATES. CAREFULLY SCREW BOLT SETS INTO BASE BOARD AS SHOWN - DO NOT TIGHTEN 100% YET. BEFORE FITTING (6) FIT BOTH PLATES (J) TO HEADEND MATTRESS BASE FIRST Page 7 of 9...
Page 8
Mattress Base Assembly - Use Pack 'B' Stage SLIDE FOOTEND MATTRESS BASE BOARD (6) INTO POSITION LOOSLEY CONNECT THE PLATES SCREWING ALL 8 SETS OF BOLTS INTO PLACE 100% WHEN ALL BOLTS ARE IN PLACE, TIGHTEN ALL 16 BOLT SETS 100% Page 8 of 9...
Page 9
Base Board Assembly Stage Warning.! Note: Be very careful what you store under the bed - the top of an item, like a suitcase or a box, must not touch the underside of the mattress base or it may get damaged.
Need help?
Do you have a question about the FRANCIS OTTOMAN BEDGAS LIFT and is the answer not in the manual?
Questions and answers