Page 1
FRANCIS OTTOMAN ELECTRIC LIFT UP BED PLEASE READ this sheet prior to assembly to familiarise yourself with the various stages of construction. Carefully open the pack supplied and check the contents against the parts and fittings check list. Do not destroy any of the packaging until you are certain that you have all the necessary parts for the assembly.
Page 2
Fittings Checklist HARDWARE NEEDED FOR BED ASSEMBLY (PACK A) Code Description Code Description Bolts (M8x30mm) for fitting side rails (3&4) to Allen Key (for M8 bolt) headboard & footboar d (1&2) Spring Washers (for M8 bolts) Bolts (M8x60mm) for fitting feet (12&13) and fitting mattress base support rails (9) to headboard &...
Page 3
Bed Assembly - Use Pack 'A' Stage Note angles point inside & Stage 10mm Page 3 of 11...
Page 4
Bed Assembly - Use Pack 'A' Stage & & Loosely fit all the bolts in place but do not tighten yet. Stage & 100% Make certain the bed is squared up as shown in the diagram then tighten all bed assembly bolts 100%. Page 4 of 11...
Base Board Assembly Stage & Electrical & Cable Connections Stage Connect Main Power Lead (16) to your wall socket - for safety, this must be an earthed supply ON/OFF SWIT H Page 5 of 11...
Bed Assembly Stage Note: Please do not pull up the support arms, PRESS they must be driven up by using the 'UP' arrowed button - drive them to a convenient position that suits your size & stature... Stage Page 6 of 11...
Page 7
Bed Assembly - Use Pack 'C' Stage Stage D A B C PLEASE DO NOT STORE ANYTHING INSIDE THIS GUARD BOX OR THE MOTOR MAY GET DAMAGED.! PLEASE DO NOT STORE ANYTHING INSIDE THIS GUARD BOX OR THE MOTOR MAY GET DAMAGED.! Page 7 of 11...
Page 8
Bed Assembly - Use Pack 'B' Stage CAREFULLY SCREW BOLT SETS INTO MATTRESS BASE BOARD AS SHOWN - DO NOT TIGHTEN 100% YET SLIDE HEADEND MATTRESS BASE BOARD (5) UP AGAINST THE LIFTING ARM STOP PLATES. BEFORE FITTING (6) FIT BOTH PLATES (J) TO HEADEND MATTRESS BASE FIRST Page 8 of 11...
Page 9
Bed Assembly - Use Pack 'B' Stage SLIDE FOOTEND MATTRESS BASE BOARD (6) INTO POSITION LOOSLEY CONNECT THE PLATES SCREWING ALL 8 SETS OF BOLTS INTO PLACE 100% WHEN ALL BOLTS ARE IN PLACE, TIGHTEN ALL 16 BOLT SETS 100% Page 9 of 11...
Page 10
Bed Assembly Stage Stage PRESS Page 10 of 11...
Page 11
Warning.! Note: Be very careful what you store under the bed - the top of an item, like a suitcase or a box, must not touch the underside of the mattress base or it may get damaged. Maximum item height is 210mm. IT IS DANGEROUS TO ALLOW CHILDREN OR SOMEONE WITH LEARNING DIFFICULTIES TO OPERATE THIS MOTOR DRIVEN OTTOMAN BED SO A CHILD-LOCK IS BUILT INTO THE CONTROLLER.
Need help?
Do you have a question about the FRANCIS OTTOMAN and is the answer not in the manual?
Questions and answers