DREAMS FLORENCE Assembly Instructions

Double bed

Assembly Instructions

Minimum No. of people

Recommended to assemble

This product.

Approx assembly time:

NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that

the bed will be used in.

Before you Start

here is some

helpful advice.

FLORENCE DOUBLE BED

1. We suggest you spend a short time reading through this leaflet and then follow

the simple step by step instructions.

2. If you follow the instructions carefully the end result should be worth the effort.

3. Do not discard any of the packaging until you have checked that you have all

the parts and the pack of fittings.

4. Assemble this product on a carpet.

5. To ensure an easier assembly, we strongly advise that all fittings are only

finger tightened during initial assembly. Only upon completion of the assembly

should all fixing points be fully tightened.

6. We recommend a periodic check on all fixing points to make sure they remain

fully tightened.

7. Keep glue and fittings out of childrenʼs reach.

In the unlikely event that this product has missing or damaged parts, please call

3 43

to obtain spares

1 of 4

Table of Contents

Do you have a question about the FLORENCE and is the answer not in the manual?

Page 1 FLORENCE DOUBLE BED Assembly Instructions Minimum No. of people Recommended to assemble This product. Approx assembly time: NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that the bed will be used in.
Page 2 Component parts and fittings contained in the box PARTS Fittings M8 x 25 mm Bolt Part No: 000 - 1234 8 pcs Ø8 mm Washer Part No: 000 - 2345 8 pcs 1 piece 8 spring washer 8pcs Part No: 000 - 3456 M6 x 35 Bolt 6pcs 2 pieces...
Page 3 ASSEMBLY STEP 1 1) Use the rubber washer (F) between the head/foot board (1&2) and side rail (3) , then use the bolt (A), washer (B) and spring washer (C) to fix the side rail (3) onto the head/footboard (1&2) NOTE: Slats not supplied shown STEP 2...
Page 4 ASSEMBLY STEP 4 1) Carefully locate the slats frame onto the bed. 2) Use bolt ( ) and JCN Nut ( ) to fix the slats frame onto the bed. 1) Carefully locate the slats frame onto the bed. Use bolt ( ) and JCN Nut ( ) to fix the slats frame onto the bed.