Hitachi Freedom Storage Lightning 9900 V series Configuration Manual page 24

The following sample instructions apply to the Qlogic
configuring other adapters, refer to the user documentation for the adapter.
®
To configure a Qlogic
1. While the system is booting up, launch the HBA setup utility as follows: when the
message Press <Alt-Q> to Run QLogic Fast! Utility appears, press Alt-Q.
®
2. Select the Qlogic adapter to configure.
3. Go to <Configuration Settings>, select <Host Adapter Settings>, and then verify the
following settings:
– Host Adapter BIOS:
– Frame size:
– Loop Reset Delay:
– Adapter Hard Loop ID:
– Hard Loop ID:
4. Go back to <Configuration Settings>, select <Advanced Adapter Settings>, and then
verify the following settings:
– Enable LIP Reset:
– Login Retry Count:
– Port Down Retry Count:
– IOCB Allocation:
5. Verify all other required settings for your operational environment. For example, the
®
Qlogic adapter defaults to eight LUNs per target. Refer to the user documentation for
the adapter as needed.
6. Repeat the preceding steps for each Qlogic
9900V subsystem. When you are finished configuring Qlogic
setup utility.
Note: Be sure to add the Qlogic
Hitachi Lightning 9900™ V Series Red Hat
2200F fibre-channel adapter connected to the 9900V:
Disabled
1024
2
Enabled
Larger than any port addresses
No
100
30
as specified in Table 2.4.
®
®
driver to the kernel.
®
2200F adapter. For instructions on
fibre-channel adapter connected to the
®
adapters, exit the HBA
Linux Configuration Guide
® ®
16