Sanitization Procedure For K5 Wow Install – Household Bleach - Kinetico K5 Manual

Section 4: Sanitization Procedure for K5 WOW Install – Household Bleach
(unscented) – uses Sanitization Kit Part No. 9392A
Note: The following steps should be taken immediately after installation; no water should be in the unit.
Safety glasses
1. Attach anti-spray line
The faucet should be closed.
anti-spray line
4. Install cartridge plugs in
all locations, except
prefilter
Install 4 plugs in these locations.
(RO, Auxiliary 1, Auxiliary 2, Post)
8. Close feed
Revised: 09/2016
and rubber/latex gloves must be worn during sanitization.
2. Close feed
The feed valve should be closed
5. Add 5 mL unscented
bleach to a sanitization
cartridge (kit 9392A) that
is half full of clean water
9. Slowly crack open faucet
to depressurize the
system
WARNING: Do
not open faucet all
the way. Air, water
and chemical
solution will spray
out forcefully. Be
prepared to control
the anti-spray line.
Drinking Water Systems
Page 19
K5 Drinking Water Station
3. Confirm jack screw is
closed
6. Slowly open feed valve
7. Wait 4 minutes
prefilter position
Note: You may hear a
buzzing sound from
the unit. This is normal
for start-up. Check for
leaks.
10. Allow system to
depressurize – leave faucet
open.
Note: Do not over tighten.
Section 7