Sanitization Procedure For K5 Wow Install – Chlorine Dioxide - Kinetico K5 Manual

K5 Drinking Water Station
Section 2: Sanitization Procedure for K5 WOW Install – Chlorine Dioxide
Note: The following steps should be taken immediately after installation; no water should be in the unit.
Safety glasses
1. Attach anti-spray line
The faucet should be closed.
anti-spray line
4. Install cartridge plugs in all
locations, except prefilter
Install 4 plugs in these locations.
(RO, Auxiliary 1, Auxiliary 2, Post)
7. Wait 4 minutes
Note: You may near
a buzzing sound
from the unit. This is
normal for start-up.
Check for leaks.
8. Close feed
select settings
Section 7
and rubber/latex gloves must be worn during sanitization.
2. Close feed
The feed valve should be closed.
5. Add cleaning agent.
Pour one package of cleaning agent
into dry cartridge plug – install plug into
cartridge prefilter position.
Cleaning Agent: Chlorine dioxide tablet
(crush tablet while still in packet) or
granules
prefilter position
9. Slowly open faucet to
depressurize the system
WARNING: Do not open faucet all the
way. Air, water and chemical solution
will spray out forcefully. Be prepared to
control the anti-spray line.
Drinking Water Systems
Page 14
3. Confirm jack screw is
closed
Note: Do not over tighten.
6. Slowly open feed valve
10. Allow system to
depressurize – close faucet.
Revised: 09/2016