Roberts Stream 218 Manual List page 17

hidden SSID, then you will need to enter some network settings manually. The typical user will not need to
used for this purpose. IPv4 address schemes are used.
1. From the radio's Network Settings menu, select 'Manual settings'. You must then choose to connect using
the 'Wireless' connection. There are as many as nine 'Wireless' settings screens, shown by the '1 of 9'
progress marker in the top right corner of the display.
DHCP - On or Off
IP address - e.g. 192.168.1.25
Subnet mask - e.g. 255.255.255.0
Gateway adress - e.g. 192.168.1.1
DNS address (primary and secondary addresses)
SSID - needed for WiFi connections if the SSID is not broadcast
WEP / WPA / WPA2 key and settings
When entering numbers, the SSID or the WiFi pass key, the three controls on the right-hand side of the
screen have special functions. You can quickly access these by pressing the Info button and then use the
Tuning control as needed:
select ' ' to erase a character just entered (long press to clear); Info again to continue
select ' ' when the complete encryption key has been entered
select ' ' to cancel and go back to the TKIP / AES options screen
3. Upon completion of the settings the radio should connect to the network. If the connection is made
successfully, the radio will return to the Network Settings menu. If the unit cannot connect, then it will display
a 'Failed to connect' message. You will then need to identify which setting may need to be changed, or
whether some other network issue is responsible. Once connected, the network settings are saved. They
are retained in memory while the radio is disconnected from the mains.
Network settings
Network wizard
PBC Wlan setup
View settings
Wlan region
Manual settings
NetRemote PIN Setup
Connection type
Wireless
IP settings
IP address
192 . 168 . 1 . 25
Subnet mask
255 . 255 . 255 . 0
SSID:
mynetwork
0 1 2 3 4 5 6 7
8 9 . _ - @ ,
a b c d e f g h
i j k l m n o p
q r s t u v w x
Network settings
Please wait
Connecting...
16