Display And Audio - Roberts Stream 218 Manual List

Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the rear of your radio is provided
for connecting the audio signal from an external audio source such as an
MP3 or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or CD
player to the Aux In socket located at the rear of the radio. Typically this
lead will have a 3.5mm stereo plug at both ends.
2. Switch on your radio and press the Mode button until AUX in mode is
shown on the display.
3. Press 'play' on the connected audio device. If you are using its headphone
output for the connection, set its volume control to a level of somewhere
between two-thirds and maximum (the objective is to get a strong audio
signal but without too much distortion). Then adjust the volume on the
radio as required.
Note, if using an iPod as the sound source, you may need to set its output
to maximum to get an adequate audio signal level.
4. After use, disconnect your player in order to listen to your radio
conventionally.
Inactive Standby feature
In order to minimise its energy consumption when not in use, your radio includes an automatic Inactive
Standby feature. This is designed to put your radio into standby if it detects that it is no longer being
used in the following circumstances.
Internet radio – streaming is stopped; Music player – music playing is stopped;
Spotify Connect – streaming is stopped; Aux-in / Bluetooth – there is no audio input signal
If any of these conditions is detected for more than 10 minutes then the radio will start a 5 minute countdown
before entering standby. The display will show the time remaining. After 15 minutes of inactivity the radio
will enter standby. If powered from batteries the radio will then switch off completely.
Pressing any button or resuming listening during the 15 minute period will reset the standby timer.

Display and Audio

DC IN
9V 1.5A
Aux In
OPEN
Standby in 5 minutes
Please press
any button to cancel.
62