Roberts Stream 218 Manual List page 12

Before you can use your Stream 218 radio to listen to Internet radio or to music streamed from your computer, it
This section of this book describes how to connect the radio to your network using the wireless (WiFi) connection.
The following instructions assume that you have just set up the clock and time options using the Setup Wizard
as described on the preceding page.
These instructions also apply to the Network Wizard in the Network Settings menu (from step 2 onwards).
1. After setting the Daylight Savings options (see page 10), the display will show the 'Keep network connected?'
option. You should choose 'Yes' if you wish to keep the radio connected to the network when it is in Standby
mode. This will allow remote control software to switch on your radio when needed.
If you choose 'No' then your radio will shut down its WiFi connection when it is in Standby, DAB, FM, Bluetooth
or Aux-in modes. This minimises power consumption but it does mean that you will need to switch the radio on
manually in order to use either Spotify Connect, the 'Play to / Cast to Device' function or any remote control
software such as the UNDOK app.
Rotate Tuning to highlight the required option and then press the control to make the selection.
After setting the Keep Connected option, the display will show a list of supported WiFi regional options.
Rotate Tuning to highlight the required region (for the UK choose 'Europe'), and then press the control to
make the selection. Your radio will then scan for available WiFi networks.
2. The radio will enter the Network Settings Wizard and will display 'Scanning...'. The radio will automatically
scan both 2.4GHz and 5GHz WiFi bands. After a short while the display will show a list of the available WiFi
networks.
11
Network settings
Keep network connected?
*
Wlan region
Europe
Network settings
Network wizard
Scanning...