Observing Other Applicable Documents - Vaillant ecoCRAFT exclusive VKK GB 1206/3-E R1 Installation And Maintenance Instructions Manual

2 Notes on the documentation
2.1

Observing other applicable documents

▶
You must observe all the operating and installation in-
structions included with the system components.
2.2 Storing documents
▶
Pass these instructions and all other applicable docu-
ments on to the system operator.
2.3 Applicability of the instructions
These instructions apply only to:
Product – Article numbers
VKK GB 806/3-E R1
0010014388
VKK GB 1206/3-E R1 0010014389
VKK GB 1606/3-E R1 0010014390
VKK GB 2006/3-E R1 0010014391
VKK GB 2406/3-E R1 0010014392
VKK GB 2806/3-E R1 0010014393
2.4 System logbook
▶
Maintain a logbook for the system (→ Page 42).
3 Product description
3.1 Serial number
The serial number can be found on a sticker behind the front
flap on the front below the control panel and on the identific-
ation plate.
3.2 Information on the identification plate
The identification plate is attached to the rear of the product
at the factory.
Information on the Meaning
identification plate
Read the instructions.
VKK... Vaillant gas-fired floor-standing condens-
ing boiler
80 Power in kW
6 with condensing technology
/3 Product series
E Comfort fittings
HL Only suitable for natural gas
ecoCRAFT exclusive Product description
G20 – 20 mbar
Gas group and gas connection pressure
as set at the factory
Cat. Approved gas category
Types Approved gas-fired units
PMS Permissible total overpressure
T Max. flow temperature
230 V 50 Hz Electric connection
0020149561_01 ecoCRAFT exclusive Installation and maintenance instructions
Notes on the documentation 2
Information on the Meaning
identification plate
W Max. electrical power consumption
IP Level of protection
Heating mode
P Nominal heat output range
Q Heat input range
Bar code with serial number,
7th to 16th digit = product article number
Note
Make absolutely sure that the product is compat-
ible with the gas group at the installation site.
3.3 Product design
3.3.1 Front view of the functional elements
6
5
4
1 Switch box
2 Air intake damper
3 Supply air pipe
1
2
3
4 Neutralisation box (op-
tional)
5 Condensate discharge
6 Condensate tray inspec-
tion opening
7