Vaillant ecoCRAFT exclusive VKK GB 1206/3-E R1 Installation And Maintenance Instructions Manual page 10

4 Set-up
4.6 Minimum clearances and installation
clearances
300
▶
When using the accessories, observe the minimum clear-
ances/installation clearances.
It is not necessary to maintain a clearance between the
product and components made of combustible materials that
go beyond the minimum clearances
The boiler shall only be sited on floors and adjacent to walls
capable of withstanding at least 65 degrees C. (However, the
recommended minimum distance must be observed).
4.7 Aligning the product
▶
Use the height-adjustable feet to align the product ho-
rizontally in order to ensure that the condensate drains
from the condensate tray.
4.8 Opening the front flap
▶
Open the front flap by lifting the silver handle bar (1).
◁
The front flap (2) automatically swivels downwards
and the control panel becomes accessible.
10
500
500
800
1
2
Installation and maintenance instructions ecoCRAFT exclusive 0020149561_01
4.9 Removing/installing the front casing
4.9.1 Removing the front casing
1. Open the front flap. (→ Page 10)
2. Undo the screw (1) above the control panel.
3. Pull the front casing in the upper area to the front and
out.
4. Raise the front casing to remove it.
5. If required, you can now remove the rest of the casing
sections.
4.9.2 Installing the front casing
1. Attach the front casing to the bottom and press on the
product until the locking bolts audibly click into place.
2. Screw in the screw for securing the front casing again.
4.10 Removing/installing the upper casing and
side sections of the casing
4.10.1 Removing the upper casing and side
sections of the casing
1. Remove the front casing. (→ Page 10)
2. Pull the upper casing forwards.
3. Remove the upper casing.
4. Pull the side sections of the casing up and out so that
the side sections are released from the mount.
5. Lift the side sections of the casing up and out.
4.10.2 Installing the upper casing and side
sections of the casing
1. Insert the side sections of the casing into the product
from above.
2. Push the top of the side sections of the casing until the
side sections click into place in the mount.
3. Place the upper casing onto the product.
4. Slide the upper casing backwards until the casing clicks
into place.
1