Installing A Filler Panel - IBM SAN768B Installation, Service And User Manual

Figure 24. Port blade removal and installation (16-port blade shown as example)

Installing a filler panel

To install a filler panel, do the following:
1. Orient the filler panel.
2. Slide the filler panel into the slot until it is firmly seated.
3. Tighten the thumb screw at the bottom of the panel.
4. Install the chassis door.
Removing and installing a control processor blade (CP8)
This section describes how to remove and install a control processor (CP8) blade.
Each SAN768B has two CP8 blades located in slot 6 and slot 7.
Note: If the new CP blade does not have the same firmware as the active CP
blade, you must upgrade the new blade to the same firmware version.
Chapter 5. Removing and installing components
57