Gbe Optical Daughter Card Ports - Cisco ASR 5500 Installation Manual

MIO Port Cabling

10 GbE Optical Daughter Card Ports

Caution:
tested and approved by Cisco. MIO and UMIO cards ship with SFP+ transceivers installed.
The 10 Gigabit Ethernet ports accept the following fiber optic to electrical signal Small Form-Factor Pluggable (SFP+)
transceiver types:
 10GBase-SR – connects the port to a multimode fiber optic cable over relatively short distances (30.80 meters).
 10GBase-LR – connects the port to a single-mode fiber optic cable over a maximum distance of 10km.
The table below lists the signaling parameters supported for the above transceiver types.
Table 11.
SFP+ Transceiver Type
10GBase-SR
10GBase-LR
The 10 Gigabit Ethernet ports on the daughter cards are only certified to work with SFP+ transceivers
SFP+ Transceiver Parameters
Parameter
Maximum transmit level
Minimum transmit level
Maximum receive level
Minimum receive level
Maximum transmit level
Minimum transmit level
Maximum receive level
Minimum receive level
Value
-1.0dBm
-7.3dBm
-1.0 dBm (saturation average power)
-11.1 (sensitivity average power)
0.5 dBm
-8.2 dBm
0.5 dBm (saturation average power)
-12.6 (sensitivity average power)
ASR 5500 Installation Guide ▄
10 GbE Optical Daughter Card Ports ▀
77