Grounding Procedure - Cisco ASR 5500 Installation Manual

Chassis Installation
Figure 10.

Grounding Procedure

Step 1
Remove the rear bottom cover from the chassis. Grasp both sides of the cover and pull out and up to unsnap the cover.
Step 2
Locate the ground terminal on the lower-left corner at the rear of the chassis.
Step 3 Use a 7/16-inch nut driver or socket wrench to remove the Kep nuts and washers from each post.
Step 4
Insert the lug connected to the grounding cable over the two posts.
Step 5
Secure the lug to the ground terminals with the Kep nuts and washers you removed in step 2. The nuts should be
torqued to 50 in-lb (5.65 N-m).
Location of Chassis Ground Terminals
1 Chassis ground point
3 2-hole lug
5 7/16-inch Kep nut
2 Grounding cable
4 Flat washer
Grounding the Chassis ▀
ASR 5500 Installation Guide ▄
55