Chapter 3
Printer Configuration
SERIES 1, 2 CH
When you select the Series 1 with 2 Characters protocol, the printer
behaves exactly the same as the Series 1 with 1 Character
protocol, except that the printer sends two-character responses to
the host. These response characters are listed in the following
table:
Online State
Online
Offline
NOTE: When using the SERIES 1, 2 CH protocol, be careful with
Baud Rate
Values: 110 to 256,000.
9600 is the default.
This parameter must be set to match your host computer.
Baud rate is the number of bits, including control bits (start/stop and
parity bits) transferred per second over the interface.
Data Bits
Values: 5 to 8 (default).
This parameter must be set to match your host computer.
Serial interfaces support 5, 6, 7, and 8-bit transfer of data words.
Most use 8-bit data transfer, but this must match the host computer.
92
Buffer State
Buffer Empty
Buffer Full
Buffer Empty
Buffer Full
the transmission of binary data (control codes, bit images,
etc.) since the printer discards poll characters.
Response Characters
1 CR
3 CR
0 CR
2 CR