Table of Contents
Advertisement
Chapter 3
Downloading Into Flash Memory
K2
WRONG FILE
CHECKSUM
K3
DC PROGRAM
NOT VALID
K4
NO FLASH FILE
SYSTEM
K5
DRAM FAIL AT
ADDRESS xxxxxxxx
K6
FLASH MEMORY
FAIL
K7
PROGRAM FLASH
FAIL AT xxxxxxxx
K8
FLASH MEMORY
FULL
K9
PROGRAM
NEEDS MORE DRAM
L0
INVALID DRAM
CONFIGURATION
122
Table 2. Flash Messages
The printer detected emulation or file
corruption during download or emulation
bootup.
Re-install the emulation or re-download the
flash files.
There is no emulation installed or the
emulation in flash memory is corrupted.
Install/re-install emulation software to the
printer.
The flash file system is corrupted or the
flash memory is unformatted.
Install/re-install emulation software to the
printer.
Contact your authorized service
representative.
Contact your authorized service
representative.
Contact your authorized service
representative.
There is not enough flash memory space for
the emulation or file download.
Initiate the flash file system optimization.
Make sure DRAM devices are all detected
by the system.
Contact your authorized service
representative.
Make sure there is a total of 32 MB of
DRAM (two 16 MB DRAM SIMMs) on the
controller board. If so, replace the DRAM, or
replace the controller board.
Advertisement
Table of Contents
