Moving Within The Configuration Menu
Movement within the configuration menus is controlled by using the
UP, DOWN, PREV, and NEXT keys. The configuration procedure
discusses this in more detail. You should not make any
configuration changes until you have a printout of your current
configuration. (See page 56.)
The following figure shows an example of the steps to follow to
change a menu option. The illustration is divided into two parts: the
left side shows a portion of a configuration menu, and the right side
shows the keys to press to access a particular parameter and
messages that display after you press each key.
The example shown configures the printer for a form length of 12
inches. It also shows how to move through any menu.
Paper Control
Image Width
Form Length
1.0 inches
2.0 inches
1.5 inches
2.1 inches
2.0 inches
2.2 inches
2.5 inches
2.3 inches
3.0 inches
2.4 inches
.
.
.
.
.
.
11.0 inches*
14.7 inches*
.
.
.
24.0 inches
30.0 inches
* equals factory default value
Moving Within The Configuration Menu
LCD Message:
Press:
ONLINE
OFFLINE
PAPER CONTROL
PAPER CONTROL
Image Width
PAPER CONTROL
Form Length
Form Length
Inch Select*
Inch Select
Length In Inches
Length In Inches
11.0*
Form Length
OR
12.0 inches
ENTER
Form Length
12.0 inches*
55