Table of Contents
Advertisement
Chapter 3
Printer Configuration
Image Width
Image Width specifies the width of the image to be printed. The
allowable range is 2.0 to 14.7 inches, in 0.1 inch increments. The
factory default is 14.6 inches.
Form Length
Form Length is the logical form length for fanfold paper. You can
specify the form length in either of two ways: in inches, or in the
number of print lines (at six lines per inch).
•
Inch Select/Length in Inches (the default). This selection allows
you to set the form length in inches. The range is from 1.0 to
30.0 inches, in one-half inch increments. The default is 11.0
inches.
•
6 LPI Select/Length at 6LPI. This selection allows you to set the
form length in lines. The range is from 6 to 144 in one line
increments. The default is 66 lines.
Paper Length
Paper Length is the physical form length for fanfold paper (the
vertical perforation to perforation distance). You can specify the
paper length in three ways: Auto Select, inches, or the number of
print lines (at six lines per inch).
•
Auto Select (the default). Using this, the printer uses the
current setting of the "Form Length" parameter to find the best
physical paper length within the valid range, and then use that
value. If the form length parameter setting is within the valid
range for the paper length parameter, the printer uses the value
for both the form length and paper length parameters. If the
form length parameter is outside the valid range for the paper
length parameter, the printer finds the closest multiple or
divisor.
70
Advertisement
Table of Contents
