5. Press ONLINE to resume printing. Note that pages have been
lost.
IMPORTANT
If Reprint on Fault is disabled and an error occurs, and if either
the "Reload Paper in Tractors" or "Not Reprinting Failed
Pages" message appears, then any pages removed from the
printer will not be reprinted, and the data on them will be lost.
Procedure for Fault Clearing-Reprint on Fault Enabled
1. A fault occurs.
2. Clear the fault condition.
3. Press CLEAR.
4. The STANDBY LED blinks and the following message appears
while the printer attempts to clear fault:
•
If the fault is not cleared:
a. The printer beeps and briefly displays the following
b. The printer then redisplays the original fault message, or
c. Attempt to clear the fault condition again, or contact your
•
If the fault is cleared, and if you do not need to reload the paper
into the tractors (for example, the printer ran out of toner):
Not Reprinting
Failed Pages
Standby ...
Clearing Fault
message:
Faults Not Cleared
any other uncleared fault message.
service representative.
Messages
215