No Paper To Load; Too Much Paper To Unload; Selected Form Is Not Loaded; No Ribbon Or Wrong Ribbon - Printek FORMSMASTER 8000SE Operator's Manual

D A I L Y O P E R A T I O N
Finally, place the printer back on line by pressing the ONLINE button.
This will automatically load the new form and begin printing. Depending
upon how the printer has been set up, the printer may start printing where it
left off or it may start at the beginning of the page where the error occurred
and reprint the entire page. See " " on page 61 for
Paper Out Fault Action
more information.

No Paper to Load

This error occurs when the LOAD button has been pressed and there is no
paper or form in the tractors. Place paper in the tractors and press LOAD
again.

Too Much Paper to Unload

This error occurs when the UNLOAD button has been pressed and there is
paper present too far beyond the tear bar. This error serves as a warning
that you may be putting forms that have already been printed on back into
the printer. Tear off any printed forms past the tear bar and press UNLOAD
again. This error also occurs if the LOAD button has been pressed and the
current form cannot be unloaded.

Selected Form is Not Loaded

This error occurs when ONLINE has been pressed and the currently selected
form is displaying <Not Loaded>. Either press LOAD to load the
selected form or select a different form and then press ONLINE.

No Ribbon or Wrong Ribbon

This error occurs when the printer is attempting to go on line and cannot
detect the presence of a ribbon cartridge. This may be due to the ribbon
not actually being present in the printer, or the ribbon may not be installed
properly.
This error may also occur when attempting to use a non-Printek brand
ribbon. Before attempting to use a ribbon brand other than Printek, please
read " " on page 10. Then if you
Why Use Only Printek® Brand Ribbons
do decide to use non-Printek brand ribbons, refer to " "
Ribbon Checking
on page 64.
39