Left/Right Select Switch - Miller Axcess E Dual Owner's Manual

6-3. Left/Right Select Switch

1
6-4. Jog/Purge
3
2
The Jog/Purge switch provides the following
functions:
• Pressing top of the Jog/Purge switch allows
the operator to feed wire without energizing
the weld power or gas valve circuit. The wire
will feed at a 60 ipm rate for 3 seconds, then
the rate ramps up to 700 ipm until the Jog
switch is released.
• The unit also provides the ability to jog the
wire feeder by means of the gun trigger.
When the gun trigger is pressed without
starting an arc, the wire will feed at run-in
speed for the first 3 seconds. During this
OM-248965 Page 22
1
time OCV (open circuit voltage) will be pres-
ent as indicated on feeder upper display. Af-
ter 3 seconds the weld output turns off and
the wire will feed at 60 ipm for the next 3 sec-
onds and then ramps up to 700 ipm until trig-
ger is released or 30 seconds elapses. If the
gun trigger is still activated after 30
seconds, the jog operation is terminated to
prevent complete unspooling of the wire and
an "REL TRIG" message is displayed on the
upper and lower displays. Releasing and
pressing the trigger again will clear the error.
.
If Start Error is enabled using the HTML
pages, an "ERR STRT" will occur after the
1 Left/Right Select Switch
Pressing the Left/Right Select
switch allows the operator to
choose which side of the units' con-
trols will operate.
.
Depressing the Left or Right
Gun Trigger also allows the
operator to enable the con-
trols on that side of the unit.
1 Jog/Purge Push Button
2 Gun Trigger Receptacle
3 Adjust Knob
first 3 seconds of run in and jogging from
the trigger is not possible.
• Pressing bottom of the Jog/Purge switch
allows the operator to purge gas lines before
welding and to preset gas pressure at the
regulator.
• This unit is equipped with Auto Thread
capability. By rocking the switch from purge
to jog within 0.5 seconds will automatically
feed wire for a factory default setting of 192
in (4877 mm) of wire before stopping. The
default feed rate is 700 ipm. These settings
can be changed using the HTML pages.
804 022-A
804 022-A