Miller Axcess E Dual Owner's Manual page 36

C. Carbon Arc Cutting (CAC)
SW
Program
Volts Time Arc Adjust
REV
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
After entering the user interface
menu, the initial display will vary by
the first item that appears.
CAC
Program
Volts Time Arc Adjust
ENBL
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Upper display push button LED
flashes to indicate this menu item
is available for selection. Press
the upper display push button.
ENBL
Program
Volts Time Arc Adjust
YES
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
The Set Up push button LED flashes
indicating that pressing this button will
enable carbon arc cutting. Press the
Set Up push button.
25
Program
Volts Time Arc Adjust
200
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Unit goes back to it standby status.
OM-248965 Page 32
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Rotate Adjust knob until Carbon
Arc Cutting Enable (CAC ENBL)
LED appears on the display.
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Rotate Adjust knob to select NO
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
To exit the user interface menu, momentarily
press the Program push button and lower
display push button at the same time.
Sequence
Trigger Control
Trigger Hold
Feeder Set Up
CAC
Volts Time Arc Adjust
ENBL
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
ENBL
Volts Time Arc Adjust
NO
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
or YES.
ENBL
Volts Time Arc Adjust
YES
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
Allows carbon arc cutting to be
enabled or disabled.
.
CAC can be loaded on any of the
eight programs by selecting the
process using the Process Set up
button.