Miller Axcess E Dual Owner's Manual page 37

D. Voltage Feedback
CAC
Program
Volts Time Arc Adjust
ENBL
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
After entering the user interface
menu, the initial display will vary by
the first item that appears.
VOLT
Program
Volts Time Arc Adjust
FDBK
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Upper display push button LED flashes
to indicate this menu item is available
for selection. Press the upper display
push button.
FDBK
Program
Volts Time Arc Adjust
VSNS
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
The Set Up push button LED flashes
indicating that pressing this button will
change the voltage feedback method.
Press the Set Up push button.
25
Program
Volts Time Arc Adjust
200
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Unit goes back to its standby status.
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Rotate Adjust knob until Voltage
Feedback (VOLT FDBK) appears
on the display.
LED
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Rotate Adjust knob to select
STUD or volt sense lead (VSNS).
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
To exit the user interface menu, momentarily
press the Program push button and lower
display push button at the same time.
Sequence
Trigger Control
Trigger Hold
Feeder Set Up
VOLT
Volts Time Arc Adjust
FDBK
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
FDBK
Volts Time Arc Adjust
STUD
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
FDBK
Volts Time Arc Adjust
VSNS
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
Allows changing the voltage feedback
method from volt sense lead to stud
feedback.
OM-248965 Page 33