Miller Axcess E Dual Owner's Manual page 39

F. Spool Reset
LOAD
Program
Volts Time Arc Adjust
BANK
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
After entering the user interface
menu, the initial display will vary by
the first item that appears.
WIRE
Program
Volts Time Arc Adjust
RST
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Upper display push button LED flashes
to indicate this menu item is available
for selection. Press the upper display
push button.
RST
Program
Volts Time Arc Adjust
ON
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
The Set Up push button LED flashes
indicating that pressing this button will
reset the wire installation date/time.
Press the Set Up push button.
25
Program
Volts Time Arc Adjust
200
WFS Amps Arc Ctl
Process
Wire Type
Gas Type
Process Set up Adjust
Unit goes back to its standby status.
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Rotate Adjust knob until Cable
Compensation (CABL COMP)
appears on the display.
LED
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
Rotate Adjust knob to select OFF
Program
Sequence
Process
Trigger Control Wire Type
Gas Type
Trigger Hold
Feeder Set Up Process Set up
To exit the user interface menu, momentarily
press the Program push button and lower
display push button at the same time.
Sequence
Trigger Control
Trigger Hold
Feeder Set Up
WIRE
Volts Time Arc Adjust
RST
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
RST
Volts Time Arc Adjust
OFF
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
or ON.
RST
Volts Time Arc Adjust
ON
WFS Amps Arc Ctl
Sequence
Trigger Control
Trigger Hold
Adjust Feeder Set Up
Allows the operator to reset the
date/time when a new spool of wire is
installed to allow wire usage tracking.
OM-248965 Page 35