Text Messages - EBS CPX200NB User Manual

– Medical alarm
– Burglary alarm
Note – for the emergency buttons to work, it is necessary to be in arm/disarm ready
mode and wait at least 10 seconds since last 0-9 key press. You can also press '*'
key to clear keypad buffer and use emergency button after that without any delay.
Fire alarm – when activated it is signaled on a keypad with all digits blinking slow.
Enter and confirm any user code to deactivate it.
Medical alarm – when activated it is signal on a keypad with the ALARM led
blinking.
Panic alarm – not signaled on a keypad.
Every emergency alarm generates an event that can be send to the monitoring
station. Events configuration is set by the installer.

7.13. TEXT MESSAGES

CPX200NB Alarm Control Unit can be managed by text messages. User can use a
variety of texts that can be send to the device in order to configure it or poll its
status. For SMS to be accepted, the phone number from which the text is being
send, has to be enlisted on the allowed numbers list. CPX200NB can store up to 10
phone numbers and up to 32 text messages. If, for any reason, the SMS can not be
send at the moment, it will be send as soon as the connection with the GSM network
is re-established but not later than 1 day after the occurrence of the event triggering
SMS send request (text messages get expired and are deleted). Message should
contain only characters from English alphabet. Furthermore, if the text contains any
spaces, content of the message, starting from the equation mark ( = ) till the end of
the message, should be enclosed in quotes (" ").
Descriptions of messages handled by the unit are listed below:
Command syntax
Command description
Feedback message
CPX200NB ALARM CONTROL UNIT – USER MANUAL
EN
Acquiring the state of partitions
XXXX GETARMED
Acquiring the information which partitions are
armed/disarmed
XXXX – user code
Example: 1234 GETARMED
PARTITION1:X, PARTITION2:Y
or
GETARMED:ERROR
21 / 30