EBS CPX200NB User Manual page 26

Assigning a text message and a phone number to the event
Command syntax
Command description
Feedback message
Feedback message
description
CPX200NB ALARM CONTROL UNIT – USER MANUAL
EN
XXXX SETUSERSMS=EVENT,TELNUM,MSG_ID
Assigning a text message and a phone number to the
event. The text will be send to the phone number
when this event occurs.
XXXX – user code
EVENT – a short name of the event, possible event
names are listed at the end of this chapter
TELNUM – ten-digit chain of zeroes and ones. Each
digit (counting from the left) represents an index of
the phone number – first digit for the first phone
number, second digit for the second number, and so
on.
0 – message will not be send to this number
1 – message will be send to this number
Example:
1234 SETUSERSMS=ARM1,1000000110,6
Means, that when ARM1 event occurs (partition 1
armed), text message number 6 will be sent to phone
numbers with indexes 1,8 and 9.
SETUSERSMS=EVENT,TELNUM,MSG_ID:OK
or
SETUSERSMS=EVENT,TELNUM,MSG_ID:ERROR
SETUSERSMS=EVENT,TELNUM,MSG_ID:OK –
command accepted
SETUSERSMS=EVENT,TELNUM,MSG_ID:ERROR –
command rejected by the system
26 / 30