Partition Handling - EBS CPX200NB User Manual

6. PARTITION HANDLING

6.1. ARMING / DISARMING WITH SELECTING PARTITIONS
1. Enter the number of the function
the user code and press
input.
Note: If incorrect code is entered the keypad will emit long
constant sound. Enter the correct code once again.
2. LEDs 1 and 2 will display the current partition state. LED on – partition armed,
LED off - partition disarmed. Only LEDs indicating the partitions the user has
access to will be on.
3. To change the partition state press buttons with partition numbers (LEDs with
relevant partition number will go on/off). Press
partitions in the away mode. Pressing and holding the
selected partitions in the stay mode. 3 beeps will confirm the change. To
cancel the entered changes, press
4. If partition arming in the away/auto mode was selected, the keypad will
indicate counting the time for leaving the facility. Leave the facility before the
time for leaving expires. After it is armed the ARMED LED will be constantly
on.
5. If the partition arming in the stay mode was selected, system will arm
immidiately. ARMED LED will turn on.
6. If partition disarming is selected, the relevant partition will be immediately
disarmed.
6.2. QUICK ARMING / DISARMING PARTITIONS
1. Enter the number of the function (
for partition two) and confirm using
to arm in the away/auto mode. To arm in the stay mode, press and hold
the button. 3-tone beep will confirm the correct code input.
Note: If incorrect code is entered the keypad will emit long
constant sound. Enter the correct code once again.
2. If partition arming in the away/auto mode was selected, the keypad will
indicate counting the time for leaving the facility. Leave the facility before the
CPX200NB ALARM CONTROL UNIT – USER MANUAL
EN
and confirm using
. 3-tone beep will confirm the correct code
.
for partition one or
. Then enter the user code and press
. Then enter
to arm selected
will arm the
13 / 30