EBS CPX200NB User Manual page 8

1. Keypad buttons
0-9 buttons and * as well as # are intended for the keypad and alarm control
unit operation. After first pressing any button, the keypad is backlit. After a few-
second idle time, backlight gets automatically dimmed. In order to make codes
easier to remember, buttons are marked with the alphabet.
2. ALARM LED (red):
Flashing light – means that alarms occurred in the system (alarms memory).
Constant light – means that system is in alarm state.
Off – system is operating correctly.
3. ARMED LED (red):
Flashing light – means that time for leaving any of the partitions is counted.
Constant light – at least one partition is armed
Off – partitions disarmed.
4. SYSTEM LED (yellow):
Flashing light – means that in the control unit's memory there are faults that has
already ceased (there was power loss, but it has already restored).
Constant light – there is a fault in the system that was not removed.
Off – no fault in the system.
5. PROG LED (blue):
Flashing slowly – service function is activated and it is one of the user functions.
Flashing – data will be entered.
Constant light – installer service function is activated.
6. 1 – 16 LEDs (red)
When LED goes on during normal operation, it means the line it is assigned to
was disrupted. Flashing LED means the zone was interlocked. After activating
service functions, LEDs display data.
7. Screwed Connectors
Connectors for connecting cables joining the keypad with the alarm control unit.
8. Cable Entry
It is a place for entering the connection cables.
9. Assembly Holes
The keypad was equipped with four round assembly holes for proper fastening
the keypad.
CPX200NB ALARM CONTROL UNIT – USER MANUAL
EN
8 / 30