Attaching The Non-F Model Processor Carrier Assembly To The Heatsink To Form The Processor Heatsink Module (Phm) - Supermicro SuperServer 1019GP-TT User Manual

Attaching the Non-F Model Processor Carrier Assembly to the
Heatsink to Form the Processor Heatsink Module (PHM)
After you have made a processor carrier assembly by following the instructions on the previous
page, please follow the steps below to mount the processor carrier assembly onto the heatsink
to create the Processor Heatsink Module (PHM).
1. Locate "1" on the heatsink label and the triangular corner next to it on the heatsink.
With your index finger pressing against the screw at this triangular corner, carefully hold
and turn the heatsink upside down with the thermal-grease side facing up. Remove the
protective thermal film if present, and apply the proper amount of the thermal grease
as needed. (Skip this step if you have a new heatsink because the necessary thermal
grease is pre-applied in the factory.)
2. Holding the processor carrier assembly at the center edge, turn it upside down. With
the thermal-grease side facing up, locate the hollow triangle located at the corner of the
processor carrier assembly ("a" in the graphic). Note a larger hole and plastic mounting
clicks located next to the hollow triangle. Also locate another set of mounting clicks and
a larger hole at the diagonal corner of the same (reverse) side of the processor carrier
assembly ("b" in the graphic).
3. With the back of the heatsink
and the reverse side of the
processor carrier assembly facing
up, align the triangular corner on
the heatsink ("A" in the graphic)
against the mounting clips next
to the hollow triangle ("a") on the
processor carrier assembly.
4. Also align the triangular corner ("B")
at the diagonal side of the heatsink
with the corresponding clips on the
processor carrier assembly ("b").
5. Once the mounting clips on
the processor carrier assembly
are properly aligned with the
corresponding holes on the back
of the heatsink, securely attach the
heatsink to the processor carrier
assembly by snapping the mounting
clips at the proper places on the
heatsink to create the processor
heatsink module (PHM).
Chapter 3: Maintenance and Component Installation
Non-Fabric CPU and Processor Clip
(Upside Down)
Triangle on the CPU
d
D
Triangle on the
Processor Clip
Heatsink
(Upside Down)
D
On Locations (A, B), the notches
snap onto the heatsink's sides
31
b
c
B
a
C
A
On Locations of (C, D), the notches
snap onto the heat sink's
B
mounting holes
C
A
Make sure Mounting
Notches snap into place