Top To Rear Vent Modification - Lopi Cypress GSR2 Deluxe Owner's Manual

10

Top to Rear Vent Modification

NOTE: The rear vent parts are included in the Minimum Vent Kit "D" (sku
96200317). If using the rear vent configuration, make sure to review vent
configuration before proceeding.
Heater Placement Requirements
• Heater must be installed on a level surface capable of supporting the heater and vent
• Due to the high temperature, the heater should be located out of traffic and away from furniture
and draperies.
• When placed in a location where the floor to ceiling height is under 7 feet, the installation is
considered an alcove and must meet the following requirements:
- The alcove floor to ceiling height must be at least 48" tall
- The alcove must not be more than 36" deep before the ceiling returns to 7'
- The alcove must be at least 51-5/8" wide
• The heater must not be placed so the vents below or above the door, along the sides of heater, or
along the back of the heater can become blocked.
• This heater may be placed in a bedroom. Please be aware of the large amount of heat this
appliance produces when determining a location.
Mobile Home Requirements
• When the stove is installed in a mobile home, it must be bolted to the floor and the appliance
grounded (use the optional blower with a grounded circuit or other suitable grounding method -
current ANSI/NFPA 70 or CSA C22.1).
Floor Protection Requirements
• When the stove is installed directly on
carpeting, vinyl or other combustible
material other than wood flooring or a
high pressure laminate wood floor, the
stove must be installed on a non-
combustible or wood protection panel
extending the full width and depth of
the heater. Make sure the four rubber-
tipped bolts below the stove contact the
floor (they dampen any noise that may
transmit through the hearth). Do not
adjust with weight on the bolts, the
rubber tips may tear.
Electrical Requirements

Plug the stove into a grounded receptacle supplying a minimum 1.5 amps (120 Volts, 60 Hz, 180
watts).

The appliance, when installed, must be electrically grounded in accordance with local codes or, in
the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
© Travis Industries
Installation
(for qualified installers only)
1/3/18 - 1444 Cypress GSR2