Log Installation - Lopi Cypress GSR2 Deluxe Owner's Manual

Finalizing the Installation

Log Installation

! The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is "OFF" and the heater is cool prior to conducting service.

Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.

If using propane (LP), convert the appliance before installing the logs (see page53).

The burner must be correctly positioned before installing the logs. Make sure the burner is fully
seated and the pilot is properly aligned. See page 53 for details on burner removal.
Preparing the Burner
The pilot shield is bent down during shipping. Before placing the logs, make sure the pilot shield is
bent up 90° (see photo below).
Ember Trays
The steel ember stands are shipped inside the firebox. Make sure the ember stands are all the
way to the back. The ceramic ember trays are shipped with the logs. Place them on top of the
ember stands with the flat edges facing inwards.
© Travis Industries 1/3/18 - 1444
(for qualified installers only)
Cypress GSR2
29