Rear Vent Configuration With No Rise - Lopi Cypress GSR2 Deluxe Owner's Manual

16

Rear Vent Configuration with No Rise

• Use the minimum vent kit "D" from Travis Industries (SKU 96200317). This kit contains the following
components used to vent the stove through a typical exterior wall:
-- Travis Thimble (unique to this stove)
-- Wall Cover (Black)
-- Pipe Section (3.9")
-- Pipe Section (6")
-- Snorkel Cap (14" – unique to this stove)
-- Rear Vent Conversion Parts (cover plates, starter sections, etc.)
• No elbows (45° or 90°) may be used (no corner installations).
• Maximum Horizontal Run of 2' (additional 8" co-axial vent may be used).
• Horizontal sections require a ¼" (6mm) rise every 12" (305mm) of travel.
• Diffuser must be closed (see page 14).
• Exhaust restrictor must be removed.
• Do not install the exhaust restrictor extender.
Max. 2' (610mm) length
© Travis Industries
Installation
Travis Snorkel
(unique to this stove)
Typical 8-1/2" (216mm)
8" Diameter Vent
(for qualified installers only)
Travis Thimble
(unique to this stove)
1/3/18 - 1444
Min. 12" (305mm)
Grade
Cypress GSR2