Table 6: Device Configuration - Grandstream Networks GWN7600LR User Manual

3. Click on Pair
acting as Master.
4. The paired GWN7600LR will appear Online, users can click on
5. Users can click on
status, users connected to it and configuration. Refer to below table for Device Configuration tabs.
Status
Clients
Configuration
under Actions to pair the discovered access point as slave with the GWN7600LR
Figure 18: GWN7600LR online
next to Master or paired access point to check device configuration for its

Table 6: Device Configuration

Shows the device's status information such as Firmware version, IP
Address, Link Speed, Uptime, and Users count via different Radio
channels.
Shows the connected Users to the GWN7600LR access point.

Device Name: Set GWN7600LR's name to be shown next to
MAC address.

Fixed IP: Used to set a static IP for the GWN7600LR, if checked
users will need to set the following:
o
IPv4 Address: Enter the IPv4 address to be set as static for
the device.
o
IPv4 Subnet Mask: Enter the Subnet Mask.
IPv4 Gateway: Enter the Network Gateway's IPv4 Address.
o
o
Preferred IPv4 DNS: Enter the Primary IPv4 DNS.
o
Alternate IPv4 DNS: Enter the Alternate IPv4 DNS.

Frequency: Set the GWN7600LR's frequency, it can be either
2.4GHz, 5GHz or Dual-band.

Band Steering: When Frequency is set to Dual-Band, users can
check this option to enable Band Steering on the Access Point,
this will help redirecting clients to a radio band accordingly for
efficient use and to benefit from the maximum throughput
supported by the client.

Mode: Choose the mode for the frequency band, 802.11n/g/b for
2.4GHz and 802.11ac for 5GHz.
GWN7600LR User Manual
to unpair it.
P a g e | 31