Factory reset button. Press for 7 seconds to reset factory default 5-95% RH (non-condensing). settings. ● Do not power cycle your GWN7600LR during system boot up or firmware upgrade. You may corrupt firmware images and cause the unit to malfunction. POWERING AND CONNECTING THE GWN7600LR...
4. Connect the Ethernet cable (RJ45) to the correct ports of your GWN7600LR. 5. Align the GWN7600LR with the Base Bracket and pull it down to the right position. 6. Install the 2x Assembled screws to fix GWN7600LR on the Mounting Bolt.
1. Locate the MAC address on the MAC tag of the unit, which is on the underside of the ● If the GWN7600LR is already paired, make sure to unpair it first, or do a factory reset. device, or on the package.
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.