Grandstream Networks GWN7600LR User Manual page 32

Note
If a GWN7600LR is not being paired or the pair icon is grey color, make sure that it is not being paired with
another GWN76xx acting as Master Access Point Controller, if yes users will need to unpair it first, or reset
it to factory default settings to make it available for pairing by other GWN76xx Access Point Controller
AP Locating
Click on , the LED of the correlated AP will blinking for 10 times, which may help to locate where the
AP is.

Channel Width: Choose the Channel Width, note that wide
channel will give better speed/throughput, and narrow channel
will have less interference. 20MHz is suggested in very high
density environment.

40MHz Channel Location: Configure the 40MHz channel
location when using 20MHz/40MHz in Channel Width, users can
set it to be "Secondary Below Primary", "Primary Below
Secondary" or "Auto".

Channel: Select "Auto" or a specific channel. Default is "Auto".
Note that the proposed channels depend on Country Settings
under System Settings–>Maintenance.

Enable Short Guard Interval: Check to activate this option to
increase throughput.

Active Spatial Streams: Choose active spatial stream if Auto, 1
or 2 streams.

Radio Power: Set the Radio Power depending on desired cell
size to be broadcasted, three options are available: "Low",
"Medium" or "High". Default is "High".

Allow Legacy Devices(802.11b): Check to support 802.11b
devices to connect the AP in 802.11n/g mode.

Custom 2.4GHz/5GHz Wireless Power(dBm): Support users to
set the wireless power.
GWN7600LR User Manual
P a g e | 32