Grandstream Networks GWN7600LR User Manual page 37

WPA Pre-Shared Key
Use MAC Filtering
Client Isolation
Gateway MAC Address
RSSI Enabled
Minimum RSSI (dBm)
Enable Voice Enterprise
Enable 11R
AES/TKIP
Set the access key for the clients, and the input range should be: 8-63
ASCII characters or 8-64 hex characters.
Choose Blacklist/Whitelist
excluded/included from connecting to the zone's Wi-Fi.
Default is Disabled.
Client isolation feature blocks any TCP/IP connection between connected
clients to GWN7600LR's Wi-Fi access point. Client isolation can be
helpful to increase security for Guest networks/Public Wi-Fi.
Three modes are available:

Internet Mode: Wireless clients will be allowed to access only the
internet services and they cannot access any of the management
services, either on the router nor the access points GWN7600LR.

Gateway MAC Mode: Wireless clients can only communicate
with the gateway, the communication between clients is blocked
and they cannot access any of the management services on the
GWN7600LR access points.

Radio Mode: Wireless clients can access to the internet services,
GWN7xxx router and the access points GWN7600LR but they
cannot communicate with each other.
The default value is "Disabled".
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet).
Type in the default LAN Gateway's MAC address (router's MAC address
for instance) in hexadecimal separated by ":".
Example: 00:0B:82:8B:4D:D8
Check to enable RSSI function, this will lead the AP to disconnect users
below the configured threshold in Minimum RSSI (dBm).
Enter the minimum RSSI value in dBm. If the signal value is smaller than
the configured minimum value, the client will be disconnected. The input
range is from "-94" or "-1".
Check to enable/disable Voice Enterprise. The roaming time will be
reduced once enable voice enterprise.
Check to enable 802.11r
GWN7600LR User Manual
to specify MAC addresses to be
P a g e | 37